Lencore Spectra i.Net: Reports User Manual Bedienungsanleitung PDF herunterladen (Seite 11)

v1.0

Lencore Acoustics Corp. One Crossways Park Drive West Woodbury, NY 11797 p 516-682-9292 f 516-682-4785 [email protected]

SPECTRA i.NET REPORTS MANUAL

USING i.NET REPORTS FOR AN i.NET SYSTEM INSTALL

If you are at a job site and the system is already installed into the area, rst start i.Net Reports and get OP values for

Masking attenuation and contour, as well as paging and music values if the job requires paging and music. If you have

the oor layout you can label OP’s and channels if desired. Otherwise you can assign zones, and/or set sound levels.

These three tasks can be completed in any order.

LABELING OP’S AND CHANNELS

To label dierent OP’s and channels, get OP values including ZoneandOPnames/Locations. Then, on the left column

click on the ViewOP’s tab and expand OPvalues by clicking the little “plus” icon next to OPValues. This brings up all

the OP’s that you selected during GetOPvalues.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Keine Kommentare

Lencore Spectra i.Net: Reports User Manual Bedienungsanleitung Seite 11